Table of Contents
Advertisement
Installation, cont'd
Figure 2-3 — Switched video outputs, and audio inputs and outputs
6
7
Audio input and output connections
8
Figure 2-4 — Captive screw connector wiring for inputs
9
Figure 2-5 — Captive screw connector wiring for output
2-4
SVS 100 Installation
6
A
L
1
R
L
B
C
OUTPUT
6
7
8
Output A and Output B, composite video outputs — Connect composite
video display, recording, or transmission devices to these BNC connectors.
The outputs of the two connectors are identical to each other and to the
decoded S-video output
7
Output C, S-video output — Connect an S-video display, recording or
transmission device to this 4-pin mini-DIN connector. The output of this
connector is identical to the encoded composite video outputs
Input 1, 2, 3, and 4 audio inputs — Each input has a 3.5 mm, 5-pole captive
screw connector for balanced or unbalanced stereo audio input. Connectors
are included with each SVS 100, but the user must supply the audio cable.
See figure 2-4 to wire a connector for the appropriate input type and
impedance level. High impedance is generally over 800 ohms.
Tip
Sleeve
Tip
Sleeve
Unbalanced Input
(high impedance)
The audio level for each input can be individually set, via the front panel or
RS-232/RS-422, to ensure that the level on the output does not vary from
input to input. See chapter 3, Operation, and chapter 5, Serial
Communication, for details.
Audio output — This 3.5 mm, 5-pole captive screw connector outputs the
selected unamplified, line level audio. Connect an audio device, such as an
audio amplifier or powered speakers. See figure 2-5 to properly wire an
output connector.
Tip
See warning
Sleeve
Tip
See warning
Unbalanced Input
INPUTS
OUTPUT
2
R
L
3
R
L
4
R
L
1
R
8
8
8
9
.
Tip
Ring
Sleeve (s)
Tip
Ring
Balanced Input
(high impedance)
Tip
Ring
Sleeve (s)
Tip
Ring
GENLOCK
IN
OUT
RS-232/422
REMOTE
.
6
600 ohms
Tip
Ring
Sleeve (s)
Tip
Ring
600 ohms
Balanced Input
(600 ohms)
Balanced Input
Advertisement
Table of Contents
