Cisco Catalyst 4500 series Administration Manual page 1574

Configuring SNMP
Table 63-3
Notification Type
Keyword
config
config-copy
cpu
eigrp
entity
envmon
flash
fru-ctrl
hsrp
ipmulticast
isis
mac-notification
msdp
ospf
pim
port-security
rf
snmp
storm-control
stpx
syslog
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
63-12
Switch Notification Types (continued)
Description
Generates a trap for SNMP configuration changes.
Generates a trap for SNMP copy configuration changes.
Allows cpu-related traps.
Enable EIGRP traps.
Note This option is only available when the enhanced multilayer image is
installed.
Generates a trap for SNMP entity changes.
Generates environmental monitor traps. You can enable any or all of these
environmental traps: fan, shutdown, supply, temperature.
Generates SNMP FLASH notifications.
Enable SNMP entity FRU control traps.
Generates a trap for Hot Standby Router Protocol (HSRP) changes.
Generates a trap for IP multicast routing changes.
Enable IS-IS traps.
This option is only available when the enhanced multilayer image is
Note
installed.
Generates a trap for MAC address notifications.
Generates a trap for Multicast Source Discovery Protocol (MSDP) changes.
This option is only available when the enhanced multilayer image is
Note
installed.
Generates a trap for Open Shortest Path First (OSPF) changes. You can enable
any or all of these traps: Cisco specific, errors, link-state advertisement, rate
limit, retransmit, and state changes.
This option is only available when the enhanced multilayer image is
Note
installed.
Generates a trap for Protocol-Independent Multicast (PIM) changes. You can
enable any or all of these traps: invalid PIM messages, neighbor changes, and
rendezvous point (RP)-mapping changes.
Generates SNMP port security traps. You can also set a maximum trap rate
per second. The range is from 0 to 1000; the default is 0, which means that
there is no rate limit.
Enable all SNMP traps defined in Cisco-RF-MIB.
Generates a trap for SNMP-type notifications for authentication, cold start,
warm start, link up or link down.
Generates a trap for SNMP storm-control. You can also set a maximum trap
rate per second. The range is from 0 to 1000; the default is 0 (no limit is
imposed; a trap is sent at every occurrence).
Generates SNMP STP Extended MIB traps.
Generates SNMP syslog traps.
Chapter 63 Configuring SNMP
OL-28731-01