Configuring A Cisco Ip Slas Monitoring Agent And Track Object - Cisco Catalyst 4500 series Administration Manual

Chapter 60 Configuring Enhanced Object Tracking
Command
Step 5
ip address dhcp
Step 6
exit

Configuring a Cisco IP SLAs Monitoring Agent and Track Object

To configure network monitoring with Cisco IP SLAs, perform this task:
Step 1
configure terminal
Step 2
ip sla operation-number
Step 3
icmp-echo {destination-ip-address |
destination hostname [source- ipaddr
{ip-address | hostname
source-interface interface-id
Step 4
timeout milliseconds
Step 5
frequency seconds
Step 6
threshold milliseconds
Step 7
exit
Step 8
ip sla schedule operation-number
{
forever | seconds
pending | now | after time
] [
seconds recurring
Step 9{
track object-number ip sla
operation-number {state |
}
reachability
Step 10
end
Step 11
show track object-number
Step 12
copy running-config startup-config
Configuring a Routing Policy and Default Route
•
:
Step 1
configure terminal
Step 2
access-list access-list-number
Step 3
route-map map-tag [permit | deny
[
sequence-number]
OL_28731-01
]
[
life
}]
start-time time |
] [
ageout
]
To configure a routing policy for backup static routing by using object tracking, perform the
following task. For more details about the commands in the procedure, see:
http://www.cisco.com/en/US/docs/ios/dial/configuration/guide/dia_rel_stc_rtg_bckup_support_TS
D_Island_of_Content_Chapter.html
]
Purpose
Acquires an IP address on an Ethernet interface from DHCP.
Returns to global configuration mode.
Enters global configuration mode.
Begins configuring a Cisco IP SLAs operation and enter IP SLA
configuration mode.
Configures a Cisco IP SLAs end-to-end ICMP echo response time
operation and enter IP SLAs ICMP echo configuration mode.
Sets the amount of time for which the operation waits for a response
from its request packet.
Sets the rate at which the operation is sent into the network.
Sets the rising threshold (hysteresis) that generates a reaction event
and stores history information for the operation.
Exits IP SLAs ICMP echo configuration mode.
Configures the scheduling parameters for a single IP SLAs operation.
Tracks the state of a Cisco IOS IP SLAs operation and enter tracking
configuration mode.
Returns to privileged EXEC mode.
Displays tracking information to verify the configuration.
(Optional) Saves your entries in the configuration file.
Enters global configuration mode.
Defines an extended IP access list. Configure any optional
characteristics.
Enters route-map configuration mode and define conditions for
redistributing routes from one routing protocol to another.
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
Configuring Enhanced Object Tracking Features
60-11