Configuring Pvlan Over Etherchannel - Cisco Catalyst 4500 series Administration Manual

Configuring PVLANs
vlan202
vlan202
Switch#

Configuring PVLAN over EtherChannel

After creating a Layer 2 Etherchannel, you can configure it with any of the four PVLAN port modes
(promiscuous host, secondary host, isolated trunk, promiscuous trunk).
This section includes the following topics:
•
•
•
•
•
Configuring a Layer 2 EtherChannel
Do the following:
Configure a VLAN as a PVLAN.
Step 1
Refer to the URL:
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/01xo/configuration/guide/pvlans.ht
ml#wp1174853
Associate a secondary VLAN with a primary VLAN.
Step 2
Refer to the URL:
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/01xo/configuration/guide/pvlans.ht
ml#wp1121802
Configuring a Layer 2 EtherChannel.
Step 3
Refer to the URL
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/01xo/configuration/guide/channel.ht
ml#wp1020670
Configuring a Layer 2 Etherchannel as a PVLAN Promiscuous Port
Perform the following task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# interface port-channel
interface-number
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
44-24
309 community
440 isolated
Configuring a Layer 2 EtherChannel, page 44-24
Configuring a Layer 2 Etherchannel as a PVLAN Promiscuous Port, page 44-24
Configuring a Layer 2 EtherChannel as a PVLAN Host Port, page 44-26
Configuring a Layer 2 EtherChannel as an Isolated PVLAN Trunk Port, page 44-27
Configuring a Layer 2 Etherchannel as a Promiscuous PVLAN Trunk Port, page 44-28
Chapter 44 Configuring Private VLANs
Purpose
Enters global configuration mode.
Specifies the LAN interface to configure.
OL_28731-01