No Signal" Is Displayed; Keystone Distortion Of Projected Image; Images Are Fuzzy Or Out Of Focus - Epson EH-TW6700W User Manual

Troubleshooting

"No Signal" is displayed

Check
Are the cables connected correctly?
Is the correct image input port selected?
Is the connected device turned on?
(Only when projecting computer image sig-
nals)
Are the image signals being output to the
projector?

Keystone distortion of projected image

Check
Is keystone distortion adjusted within the cor-
rection range?

Images are fuzzy or out of focus

Check
Has the focus been adjusted?
Is the lens cap attached?
Is the projector at the correct distance?
Has condensation formed on the lens?
Interference or distortion appear in images
Check
Are the cables connected correctly?
Check that all the cables required for projection are securely
connected. p.20
s
Switch the image with the source buttons on the remote control.
p.28
s
Turn on the device.
Change it so that the image signal is set to external output, and
not just the computer's LCD monitor. For some models, when
the image signals are output externally, they no longer appear
on the LCD monitor.
For the computer's specifications, see the documentation sup-
plied with the computer.
If the connection is made while the power of the projector or the
computer is already turned on, the Fn key (Function key) that
changes the computer's image signal to external output may not
work. Turn the power for the computer and the projector off and
then back on again.
If projecting the image from outside of the correctable range,
you may not be able to correct the keystone distortion com-
pletely. Install the projector horizontally in front of the screen as
far as possible, and then adjust the projection position using lens
shift. p.15
s
Adjust the focus. p.31
s
Remove the lens cap.
Check the recommended projection range.
If the projector is suddenly taken from a cold environment to a
warm environment, or if sudden ambient temperature changes
occur, condensation may form on the surface of the lens, and this
may cause the images to appear fuzzy. Set the projector up in
the room about one hour before it is used. If the projector is wet
from condensation, turn off the projector, disconnect the power
cord, and leave it for a while.
Check that all the cables required for projection are securely
connected. p.20
s
106
Remedy
Remedy
Remedy
p.17
s
Remedy