Commissioning Basic Functions; Selecting The Stop Mode - Siemens SINAMICS V20 Operating Instructions Manual

Commissioning via the built-in BOP
5.6 Function commissioning
● Motorized potentiometer (MOP) mode selection (P1031 to r1050)
● ON/OFF2 function for digital inputs (P0701)
A new value is added to parameter P0701 to run the motor with the ON command or
cancel the inverter pulses with the OFF2 command.
● Parameter cloning (Page 343) (P0802 to P0804, P8458)
● PID controller (Page 90) (P2200 to P2355)
● Pre-configured connection macros and application macros (P0507, P0717) (see also
"Setting connection macros (Page 62)" and "Setting application macros (Page 73)".)
● Programmable V/f coordinates (P1320 to P1333)
● Protection of user-defined parameters (P0011, P0012, P0013)
● Skip frequency and resonance damping (P1091 to P1101, P1338)
● Sleep (hibernation) mode (Page 122) (P2365 to P2367)
● Slip compensation (P1334 to P1338)
● Super torque mode (Page 108) (P3350 to P3356)
● Text menu display (P8553) (see also "Setting motor data (Page 60)" and "Setting
common parameters (Page 76)".)
● User access level control (P0003)
● USS/MODBUS communication on RS485 (P2010 to P2037) (Page 165)
● Various stop mode selection (Page 82) (P0840 to P0886)
● Wobble function (Page 123) (P2940 to r2955)
5.6.2

Commissioning basic functions

5.6.2.1

Selecting the stop mode

Functionality
Both the inverter and the user have to respond to a wide range of situations and stop the
inverter if necessary. Thus operating requirements as well as inverter protective functions
(e.g. electrical or thermal overload), or rather man-machine protective functions, have to be
taken into account. Due to the different OFF functions (OFF1, OFF2, OFF3) the inverter can
flexibly respond to the mentioned requirements. Note that after an OFF2 / OFF3 command,
the inverter is in the state "ON inhibit". To switch the motor on again, you need a signal low
→ high of the ON command.
82
SINAMICS V20 Inverter
Operating Instructions, 11/2016, A5E34559884-006