Table of Contents
Advertisement
Wiring
Harness 4: 7-Pin Mini Black Connector
White/Violet Wire: Positive Safety Shut Down Input
This wire provides an instant shutdown for the remote start, whenever it receives +12 volts. If the brake lights
switch in the vehicle switches +12 volts to the brake light circuit, connect this wire to the output side of the
brake switch. This will allow the remote start to shut down if an attempt is made to operate the vehicle
without the key while running under the control of the remote start. In most vehicles, in order to shift gear,
the brake pedal must be depressed. The brake input will in turn cause the remote start unit to shut off. A relay
may be required if the brake light switch is (-) type.
Switch Closes when
Brake is Depressed
Black/White Wire: (-) Remote Start Enable Toggle Switch Input, (-) Neutral Safety Switch Input
When the Black/white wire is grounded, the remote start unit is operable. When this wire is disconnected
from ground, the remote start is disabled.
1. An optional remote start toggle switch can be added on to temporarily disable the Remote Start Device. It
can prevent the vehicle from being remote started accidentally. This feature is useful if the vehicle is being
serviced or stored in an enclosed area. To disable the remote start, move the optional remote start enable
toggle switch to the OFF position. To enable the remote start, move the optional remote start enable toggle
switch to the ON position.
2. If needed, this wire can connect to the Park/Neutral switch in the vehicle (See Testing in this manual).
Important Note: Directly connect the Black/White wire to the "Ground" when this
wire is not used for it's intended safety purpose or remote start will not operate.
+12 Volts
Brake
Pedal
(continued)
White/Violet Wire
To Lights
Brake Light
Bulbs
Black
7-Pin Mini
Connector
9
Advertisement
Table of Contents
