Table of Contents
Advertisement
Fixed Crank Additional Programming
If you have selected Elapsed Timer, you may be required to program 1 additional feature as enclosed.
Step 1
Turn the ignition switch from the
OFF position to the ON position 3
times leaving it in the OFF position
the third time.
Step 4
If all things seem correct, press the
( * - * ) button to stop the engine
running. If a cranking problem is
noticed, move to Step 6 to adjust the
start timer feature otherwise follow
Step 5 and get out of the
programming mode.
Step 7
After adjusting the stat timer press
the ( * - * ) button on the transmitter
to start the engine by remote. Listen
for an over-run or under-run
indication. Re-adjust as needed.
22
Step 2
9X + 1X (Hold)
3X
Before 15 seconds has passed, push
and release the valet switch 9 times
then push the valet switch a tenth time
and hold it down until 5 short
chirps/beeps + 1 long chirp beep is
heard then release it.
Step 5
Press the (Lock) button on the
transmitter to get out of the
programming mode. You will hear 3
long chirps and get 3 parking light
flashes for confirmation.
Step 8
Press the (Lock) button on the
transmitter to get out of the
programming mode. You will hear 3
long chirps and get 3 parking light
flashes for confirmation.
Step 3
Press the ( * - * ) button on the
transmitter to start the vehicle. If
everything is correct, the engine will
crank and fire without over-running
or under-running the starter.
Note: Let engine run for 10 seconds
or more to ensure proper operation.
Step 6
If the engine cranks too long or not
long enough, you may need to
adjust the start timer. Press the
(Unlock) button on the transmitter
to change the start timer length as
shown in the chart (page 18). Follow
the chart and listen for the different
chirp count to select the time you
want to use.
Advertisement
Table of Contents
