Table of Contents
Advertisement
Remote Start Operation and Feature Programming
Examine the two feature charts enclosed and decide which features to change. Circling the feature to be changed
will make the programming process much easier to perform.
Stage 1: Remote Start Feature Programming
Turn the ignition switch from the OFF position to the
ON position 3 times leaving it in the OFF position the
third time.
Use the transmitter buttons as illustrated to adjust the features required. Keep re-pressing the transmitter button
that relates to the feature you want to adjust until the correct amount of chirp/beeps is heard. Then move on to the
next feature.
One Chirp
Button
LED One Pulse
(Factory Default Setting)
Gasoline
Engine
10 Minute Run Time
Factory Alarm Disarm
with Channel 2 "On"
Constant Parking
Light Output
Press the ( * - * )
+
Button = Activates
Remote Start
+
3 Hour Time Start
(continued on the next page)
Step 1
Remote Start Feature Programming
Two Chirps
LED Two Pulse
Diesel Engine and
10 Second Warm Up
20 Minute Run Time
Without this Feature
Flashing Parking
Light Output
Press the (Lock) + ( * )
Button = Activates
Remote Safe Start
2 Hour Time Start
3X
Before 15 seconds has passed, push and release the valet
switch 7 times then push the valet switch a eighth time
and hold it down until 4 short chirps/beeps + 1 long chirp
beep is heard then release it. You are now in Stage 1
Remote Start Feature Programming Mode.
Step 3
Three Chirps
LED Three Pulse
Diesel Engine and
15 Second Warm Up
30 Minute Run Time
Press the ( * ) Button =
Activates Remote Start
Step 2
7X + 1X (Hold)
Four Chirps
LED Four Pulse
Diesel Engine and
20 Second Warm Up
5 Minute Run Time
17
Advertisement
Table of Contents
