Marksman M7a Installation Manual page 8

Wiring
Harness 3: White 5-Pin Mini Connector
Pink Wire: (continued)
Start Status: (Shock Sensor Bypass Control) Output: (See Alarm Feature Stage 3 Programming)
This wire is designed to bypass the shock sensor while remote start is operating. This wire will also supply an output
for an additional 3 seconds after the remote start unit is turned off.
Gray Wire: Channel 2 (Trunk
Release) Output
This will become a 1 second pulse
ground by activating channel 2 on
transmitter for two seconds, the
current capacity of this wire is
200mA. This feature allows you to
remote control trunk release or other
electric device.
Harness 4: 7-Pin Mini Black Connector
Blue Wire: (-) Negative Instant Trigger Input
This wire is the ground trigger input wire for hood/trunk pin switches.
Green Wire: (-) Negative Door Trigger
This wire is the ground trigger input wire for negative door pin switch.
Violet Wire: Positive Door Trigger
This wire is the positive trigger input wire for positive door pin switch.
White/Black Wire: Negative Safety Shut Down Input
The White/Black wire provides an instant shutdown for the remote start, whenever it is grounded. Connect the wire
to the hood pin switch previously installed. this wire must be routed through a grommet in the firewall and
connected to the hood pin switch. If the pin switch is to be used with an alarm system, connect this wire with
diode. Diodes are required when the hood pin is used as a triggering device. Wire as shown.
Important! This connection is a
safety wire and must be connected
as shown and tested as specified.
Failure to do so may result in
personal injury or property damage.
See detail or wiring in the following
diagram. This wire may also be used
if the vehicle brake light circuit
switches ground to the brake lights.
An isolation diode must be used for
ground switched brake light circuits
and must be connected to the output
of the brake switch.
8
(continued)
Gray
Wire
86
White 5-Pin
(Relay Not Supplied)
Mini
Connector
White/Black Wire
Negative Safety
Black 7-Pin
Mini Connector
Output to Power
Trunk Switch
87
To Constant +12 Volts
85
30
Input to Relay (+ or -)
Hood Pin Switch
To Alarm Instant
Trigger Blue Wire
Diode Diode