Marksman M7a Installation Manual page 18

Remote Start Operation and Feature Programming
Button One Chirp, LED One Pulse
(Factory Default Setting)
Turbo Timer Control
Function is Off.
The alarm can not be armed
while the engine is running.
Four Chirps, LED Four Pulses
+
Built-in Turbo Timer Control is
Press the (
before removing the ignition key
to activate the 1 minute Turbo
timer control. The alarm system
can be armed and the shock
sensor will be by-passed.
Turn On the Ignition
3 long chirps and 3 flashes of the parking lights will confirm exit
of the programming mode.
Note: Waiting 15 seconds after the last command will also cause
the system to automatically exit the programming mode.
Stage 2: Remote Start Operation Programming
In this mode you will program the type of engine starting detection you want to use in your installation. There are
3 types available:
1. Tachometer (RPM) Detection: (Most reliable and recommended) This type of detection requires
a hard wire connection to the vehicles ignition coil.
2. Voltage Detection: This method detects the drop and rise in the battery voltage when the vehicle is started by
remote. This type of detection requires a solid main power input connection but it does not require any
additional hard wire connections.
3. Elapsed Timer: This method is the easiest for installation but is not always the best method for year round
usage (Summer and Winter). To operate this method, you will program a specific time window for the remote
start unit to crank the engine. Battery strength, environment and the aging process of the vehicle may require
the timer to reset from time to time or season to season.
18
Two Chirps, LED Two Pulses
The vehicle has an aftermarket
The alarm system can be armed
with the engine running. The
shock sensor will be bypassed
as long as the engine is running.
Five Chirps, LED Five Pulses
Built-in Turbo Timer Control is
Active
+ ) buttons Press the (
before removing the ignition key
to activate the 3 minute Turbo
timer control. The alarm system
can be armed and the shock
sensor will be by-passed.
Step 4
turbo timer installed.
Active
+ ) buttons
Three Chirps, LED Three Pulses
The vehicle has an aftermarket
turbo timer installed.
the alarm system can be armed
with the engine running. The
shock sensor will be bypassed
for 3 minutes.
Six Chirps, LED Six Pulses
Built-in Turbo Timer Control is
Active
Press the ( + ) buttons
before removing the ignition key
to activate the 5 minute Turbo
timer control. The alarm system
can be armed and the shock
sensor will be by-passed.