Ricoh B064 SERIES Service Manual page 1346

ERROR CODES
Code Meaning
22-01
Memory overflow while
receiving
22-02 Tx or rx job stalled due to
line disconnection at the
other end
22-04 The machine cannot store
received data in the SAF
22-05 No G3 parameter
confirmation answer
23-00 Data read timeout during
construction
25-00
The machine software resets
itself after a fatal
transmission error occurred
F0-xx V.34 modem error
F6-xx SG3 modem error
B819/B820
CÓPIA NÃO CONTROLADA
Wait for the files in the queue to be sent.
Delete unnecessary files from memory.
Transfer the substitute reception files to an another
fax machine, if the machine's printer is busy or out of
order.
Add an optional SAF memory card or hard disk.
The job started normally but did not finish normally;
data may or may not have been received fully.
Restart the machine.
Update the ROM
Replace the FCU.
Defective FCU board or firmware.
Restart the machine.
Replace the FCU.
Update the ROM
Replace the FCU.
Replace the FCU.
Update the SG3 modem ROM.
Replace the SG3 board.
Check for line noise or other line problems.
Try communicating another V.8/V.34 fax.
36
CÓPIA NÃO CONTROLADA
Suggested Cause/Action
SM