Takeuchi TCR50 Operator's Manual page 14

SAFETY
Preparing Precautions
Know the working area
Before starting operation, know the working
area to ensure safety.
� Check the topography and ground
condition of the working area, or the
structure of the building when working
indoors, and take the necessary safety
measures in dangerous spots.
� Note and avoid
obstructions such as ditches, holes, trees,
cliffs, overhead electrical wires or areas
where there is danger of a slide.
� When working on roads, be sure to take
into account the safety of pedestrians and
vehicles.
• Use a flagman and / or signals.
• Fence off the working area and prohibit
entry to unauthorized persons.
� When working in water or crossing shallow
streams or creeks, check the depth of the
water, the solidity of the ground, and the
speed of the current beforehand. Make
sure the water is not deeper than the
allowable depth.
Refer to the section titled "Cautions on
Use in Water" for further instructions.
S2A005
all hazards and
Check the strength of the bridge
When traveling over a bridge or other
structure, check the permissible load.
If the strength is insufficient, reinforce it.
Always keep the machine clean
� Clean windows, mirrors and lights to
ensure good visibility.
� Wipe off any oil, grease, mud, snow or ice,
to prevent accidents due to slipping.
� Remove all loose objects stored in the
machine and all objects which do not
belong in or on the machine and its
equipment.
� Remove any dirt, oil or grease from the
engine area, to prevent fires.
� Clean the area around the operator's seat,
removing any potential obstacles.
12
S2A006
S2A007