Long-Term Storage - Takeuchi TCR50 Operator's Manual

MAINTENANCE

Long-term Storage

Procedures for storage
If the machine is to be stored for 30 days or
more, store it indoors. If it must be stored
outdoors, stop it on wood laid out on a flat
surface and place a waterproof cover over it
so that it stays dry.
1. Clean the machine.
2. Inspect for oil leakage, water leakage and
loose nuts and bolts.
3. Add fuel and replace the hydraulic oil and
oil.
4. To prevent rusting and freezing, replace
the engine coolant with long-life coolant
(LLC).
Refer to page 120 "Cleaning the Engine
Cooling System".
5. Use the grease gun to supply grease to
the grease nipples.
6. Fully lower the dump body.
7. Apply rust-prevention oil to the hydraulic
cylinder rods.
8. Disconnect the cable from the battery's
"–" terminal and cover the battery to
prevent freezing.
During storage
� Do not operate the engine in an enclosed
area without adequate ventilation.
� If natural ventilation is poor, install
ventilators, fans, exhaust extension
pipes or
devices.
1. To prevent rusting, operate the machine
once a month so that the oil is fully
circulated.
2. Inspect the battery and recharge it if
necessary.
Have the battery charged by a Takeuchi
sales or service outlet.
Starting the machine after storage
IMPORTANT: If
storage" have not been performed and
the machine has been stored for a long
period of time, consult a Takeuchi sales
or service outlet before reusing the
machine.
1. Wipe off the rust-prevention oil that was
applied to the hydraulic oil cylinders'
piston rods.
2. Add fuel, oil and grease to all parts.
130
WARNING
other artificial
the "Procedures
venting
for