Setup - Pass: Calibration Password Security; Figure 4-4: Setup - Enable Calibration Password Security - Teledyne T100 Instruction Manual

Teledyne ML - T100 UV Fluorescence SO2 Analyzer
4.3.2. SETUP – PASS: CALIBRATION PASSWORD SECURITY
CAL. PASSWORD
default state is
OFF
The T100 calibration functions may be password protected for to prevent inadvertent
adjustments. When the calibration password has been enabled using the PASS menu
item found under the Setup Menu (refer to below), the system will prompt the user for a
password anytime that CAL, CALZ or CALS is activated.
The default status of the calibration password is OFF. To enable the calibration
password press:
SAMPLE RANGE = 500.0 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS : 818
8 1 8
SETUP PRIMARY SETUP MENU
CFG DAS RNGE PASS
SETUP CAL. PASSWORD ENABLE: OFF
OFF
SETUP PASSWORD ENABLE:
ON
SETUP PASSWORD ENABLE: ON
ON
Figure 4-4: SETUP – Enable Calibration Password Security
SO2 =XXX.X
SETUP
ENTR EXIT
CLK MORE EXIT
ENTR EXIT
ON
ENTR EXIT
ENTR EXIT
Operating Instructions
ENTR accepts
displayed
password value
EXIT returns to
SAMPLE display
Toggles
password
status On/Off
ENTR accepts
the change
EXIT ignores
the change
85