Master Cylinder; Fluid Level; Brake Disc, Brake Pad; Change The Brake Fluid - KEEWAY 500ATV Service Manual

3. CHECKS & ADJUSTMENT
3

Master Cylinder

Fluid level

Check the brake fluid level When the brake
fluid level is near to the lower limit line, check master
cylinder, brake hoses and joints for leakage.
Remove the two mounting screws on fluid reservoir cap
.
add DOT3 or DOT4 brake liquid till the upper
limit line.
Do not mix with dust or water when adding
brake fluid.
Use only the recommended of brake fluid to avoid
chemical reaction.
Brake fluid may cause damages to the
surface of the plastic and rubber parts.
Keep the fluid away from these parts.
Slightly turn the handlebar left and right till the
master cylinder is in horizontal, then remove the fluid
reservoir cap.

Brake Disc, Brake Pad

< Wear of brake pad>
Check the brake pad wears from the mark as indicated.
Replace the brake pad if the wear has reached position
of wear limit trough.
Note
The brake pad must be replaced with a whole set.
Checking and replacing the brake disc
Front brake disc thickness: ≤3 mm →Replace
Rear brake disc: ≤4 mm →Replace
Min. limited thickness of the front brake disc:.3mm
Min. limited thickness of the rear brake disc:4mm

Change the Brake Fluid

< Changing Brake Fluid>
Change the brake fluid once every year.
3-7