11. BATTERY,CHARGING SYSTEM
11
Battery
Remove
Note:
Keep the ignition switch at OFF before operation.
Remove:
Remove the two screws and the battery cover.
Remove the holder band of battery.
Loosen negative pole screw and disconnect.
negative lead.
Remove positive pole cap and screw.
Disconnect positive lead
Remove battery.
Installation:
Reverse the removal procedure for installation.
Note:
Apply clean lubricant grease to the pole after
installation.
Install cap firmly on the positive pole after installation.
Inspection:
Measure voltage between battery terminals, and
check test status.
Complete test: 12.8V
Insufficient test: <11.8V
Insufficient charge: Recharge
Note:
When recharging after normal charging, measure
the voltage between terminals after 30 minutes.
Measuring immediately after recharging will not gain
the correct test due to the sharp voltage changes
between the terminals.
Battery
Note:
Usually no hydrogen will be generated during
charging except when overcharged. Keep away
from fires when charging.
Charge according to the current and time specified
on the label of battery.
11-4