Vice Shaft Combination Decomposition Remove Check; Wheel Gear Check Up - KEEWAY 500ATV Service Manual

9.

Vice shaft combination decomposition remove check

According to the list of instructions on the order
1 Into reverse components
2 Sliding set of 2
3 washerΦ23.5*Φ33*1
4 Sliding set of 1
5 C form block circle

9.1wheel gear check up

9.1.1.
Check the vice shaft gear tooth surface five have
crack, pitting corrosion defects, such as a crack,
pitting
the serious gear replacement or vice axis.
9.1.2The reverse gear components and low gear
components contains copper sets, such as copper set of
severe worn, within the prescribed scope is replaced
copper or a gear.
Inner diameter standards into reverse ： 23.52-23.541
mm
Low gear inner standard：26.02-26.041 mm
6. Engine Removal;Inspection & Installation
6 Bridge active tooth
7 washerΦ26*Φ35*1.5
8 Low block gear components
9 washerΦ26*Φ35*1
10 countershaft
6-46