Fuel Sensor; Connect Connector - KEEWAY 500ATV Service Manual

13. Lighting, Instruments, Switches

Fuel Sensor

13
Remove:
--Fuel tank (→2-11)
--5 fixing bolts
--Fuel sensor
Disconnect connector
Inspection
Remove fuel sensor (refer to above steps)

Connect connector

Turn ignition switch to ON
Shake fuel sensor float with hand, locate the float
position and check if it conforms to the fuel gauge
reading.
Non-conformity: →check main cable for damage or
short circuit
→Check fuel sensor and fuel gauge
Remove fuel sensor connector.
Connect multimeter between connector terminals.
Shake float with hand and measure the resistance of
float at different positions.
Connection Terminal:
Upper: Yellow/White-Green: 3-10Ω(20℃)
Lower: Yellow/White -Green: 100-110Ω(20℃)
Faulty fuel sensor: → Replace
13-9