Garmin G500 Pilot's Manual page 257

IR SAT Data Viewing Range
The IR SAT Data Viewing Range option allows you to select the map range
where at and below that value IR SAT weather products will be shown on the
selected MFD Wx Data Link Map page (1, 2, or 3). When Off is selected, IR SAT
will not be shown. In the figure below where 200 NM is selected, IR SAT data
will be shown at map ranges of 200 NM and lower.
Figure 4-99 GFDS IR SAT Viewing Range Selection
1) While viewing a WX Data Link Map page of the WX page group, press the
MENU key to display the Page Menu Options . Turn the large MFD knob to
highlight the Weather Setup option and press ENT
2) Turn the large MFD knob to highlight IR SAT Data Viewing Range. Turn the
small MFD knob to highlight the desired value.
3) Turn the small MFD knob to highlight the desired value. Press ENT to accept
the displayed value. The next option will be highlighted.
4) Press the small MFD knob to cancel selection or to end editing and return to
the WX page or turn the large MFD knob to the next option.
190-01102-02 Rev. E Garmin G500 Pilot's Guide
.
4-99