Identifying The Processor Type; Installing A Dimm - HP HPE ProLiant ML110 Gen9 User Manual

Identifying the processor type

The processor type installed in the server is briefly displayed during POST. To view this information and
additional processor specifications, do the following:
Reboot the server.
1.
The server restarts and the POST screen appears.
Press F9.
2.
The System Utilities screen appears.
Select System Information | Processor Information.
3.
The Processor Information screen shows detailed information about the processor installed in the
server.
Press Esc until the main menu is displayed.
4.
Select Reboot the System to exit the utility and resume the boot process.
5.

Installing a DIMM

Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
3.
Remove the access panel (on page 17).
4.
If installed, remove the PCI air baffle (on page 20).
5.
Remove the system air baffle (on page 21).
6.
Open the DIMM slot latches.
7.
Install the DIMM.
8.
Install the system air baffle (on page 22).
9.
If removed, install the PCI air baffle
10.
Install the access panel (on page 18).
11.
Return the server to an upright position.
12.
Connect each power cord to the server.
13.
Connect each power cord to the power source.
14.
("Install the PCI air baffle" on page 20).
Hardware options installation 67