M.2 Ssd Enablement Option - HP HPE ProLiant ML110 Gen9 User Manual

Install the Smart Storage Battery, and then connect the battery cable to the system board connector.
8.
Install the system air baffle (on page 22).
9.
If removed, install the PCI air baffle
10.
Install the access panel (on page 18).
11.
Return the server to an upright position.
12.
Connect each power cord to the server.
13.
Connect each power cord to the power source.
14.
Power up the server.
15.

M.2 SSD enablement option

To install the component:
Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
3.
Remove the access panel (on page 17).
4.
If installed, remove the PCI air baffle (on page 20).
5.
Remove the system air baffle (on page 21).
6.
Install the SSD module on the M.2 SSD enablement board:
7.
Insert the SSD module into the SSD slot at a 45 degree angle, and then gently press it down
a.
against the M.2 SSD Enablement board.
Secure the SSD module to the M.2 SSD enablement board with a screw.
b.
("Install the PCI air baffle" on page 20).
Hardware options installation 49