If you want to print only a few of the panels without printing the entire poster, click Panel
Selection, click the panels that you do not wish to print, then click OK.
Click OK to save the settings and close the Layout dialog
box.
Click Print to start
printing.
How to make a poster from your printouts
Here is an example of how to make a poster with 2x2 selected under Poster Printing and Overlapping
Alignment Marks selected as the print cutting guide. Refer to the accompanying illustrations as well.
Cut off the margin of Sheet 1 along a vertical line through the center of the top and bottom cross
marks, as shown in the illustration below.
[Top]