Connecting The Intellichem Controller To An Automation Control System - Pentair intellichem Installation And User Manual

CONNECTING TO AN AUTOMATION CONTROL SYSTEM
Wiring IntelliChem
IntelliChem AC Power Wiring Instructions:
a stand alone device (with a time clock) or with an IntelliChlor salt chlorine
generator, IntelliChem MUST BE CONNECTED TO THE LOAD SIDE OF THE
FILTER PUMP RELAY located in the load/power center (see page 40 for
IntelliChem AC power wiring diagram). This ensures that IntelliChem will only
dispense chemicals when the filter pump is ON.
For IntelliTouch
pump (or 2-speed pump) and an IntelliChlor
AC power center wires must also be connected to the LOAD SIDE OF THE
MAIN FILTER PUMP RELAY located in the load/power center (see page 40 for
diagram). This ensures that IntelliChem controller and IntelliChlor SCG only
produce chlorine when the main filter pump is on.
The following wiring diagram (see next page) shows the IntelliChem controller AC power
wiring and COM port connections to the EasyTouch, IntelliTouch and SunTouch control
system.
Controller AC Power to Filter Pump Relay
®
, EasyTouch or SunTouch
® ®
When using IntelliChem as
control system using an IntelliFlo
®
(SCG), the IntelliChlor controller
®
INTELLICHEM Controller Installation and User's Guide
®
39
®