Connecting External Devices To Intellichem Controller - Pentair intellichem Installation And User Manual

32

Connecting External Devices to IntelliChem Controller

External Devices such as pumps, CO2 devices and alarms can be connected to either
of the dry contact relays (EX_RELAY 1 and EX_RELAY 2). Relay contact ratings: 5
AMPS, 250VAC/30VDC located on the IntelliChem
diagram below and "Plumbing the Flow Cell" on page 35.
supplied to the relay terminals Ex_Relay1 and Ex_Relay2 from
certified electrician or a qualified pool professional in accordance with the
current National Electrical Code (NEC), NFPA 70 or the Canadian Electrical Code
(CEC), CSA C22.1. All applicable local installation codes and ordinances must
also be adhered to. Improper installation will create an electrical hazard which
could result in death or serious injury to pool users, installers or others due to
electrical shock, and may also cause damage to property.
INTELLICHEM Controller Installation and User's Guide
®
BE SURE TO DISCONNECT ALL SUPPLY CONNECTIONS BEFORE
SERVICING THE INTELLICHEM
Wiring external devices must be performed by a licensed
Controller circuit board. See wiring
®
CONTROLLER. AC Power may be
®
other sources.
External Device Wiring Diagram
External Devices:
EX_RELAY 1 and
EX_RELAY 2,
contact ratings:
5 AMPS,
250 VAC/30 VDC