Advertisement
IntelliChem
The IntelliChem Controller firmware updates are performed using the update
programmer connected to a USB port on a computer running Microsoft
version 10, 8, or 7.
Connect Programmer Cables
1.
Disconnect power to the IntelliChem Controller. Open the front the
cover and disconnect the 18 VAC supply connector J10 on the right
side of the IntelliChem Controller circuit board (as shown below).
2.
Note: If there is a mini-circuit board connected to the IntelliChem
Controller circuit board, disconnect the ribbon cable from the
IntelliChem Controller circuit board.
Disconnect
ribbon cable
(mini-circuit
board)
3.
Locate the 6-pin header labeled ISP in the upper-left corner of the
IntelliChem Controller circuit board (as show below).
6-pin header
ISP programming
®
Controller Firmware Update Instructions
Mini-circuit board
port
IntelliChem Controller Firmware Installation Guide
3
®
Windows
AC Power
Supply
(18VAC)
Connector
(J10)
Advertisement
