Printing Takes Too Long - Xerox Phaser 6510 User Manual

Troubleshooting
Probable Causes
There is a network-connectivity issue.
There is a wireless network setup or
connectivity issue.

Printing Takes Too Long

Probable Causes
The printer is set to a slower printing mode.
For example, the printer could be set to print
on Heavyweight paper.
The printer is in Power Saver mode.
The way the printer was installed on the
network could be an issue.
The job is complex.
The print-quality mode in the print driver is
set to Enhanced.
126 Xerox Phaser 6510 Color Printer
® ®
User Guide
Solutions
If the printer is connected to a network:
a.
Verify that the Ethernet cable is connected to the printer.
b.
On the printer Ethernet connector, verify that the green LED
is On. If not, reseat both ends of the Ethernet cable.
c.
Examine the TCP/IP address in the Communication section
of the Configuration Report. For details, refer to
Configuration Report
d.
If the TCP/IP address is 0.0.0.0, the printer needs more time
to acquire an IP address from the DHCP server. Wait 2
minutes, then print the Configuration Report again.
e.
If the TCP/IP address is unchanged, or begins with 169,
contact your network administrator.
Verify that the Wireless Network Adapter is installed and properly
configured. For details, refer to Connecting to a Wireless Network.
Solutions
It takes more time to print on certain types of special paper. Ensure
that the paper type is set properly in the driver and at the printer
control panel. For details, refer to
It takes time for printing to start when the printer is coming out of
Power Saver mode.
Determine if a print spooler or a computer sharing the printer is
buffering all print jobs and then spooling them to the printer.
Spooling can slow print speeds. To test the speed of the printer,
print some information pages such as the Demo Page. For details,
refer to Printing Reports on page 28. If the page prints at the rated
speed of the printer, there could be a network or printer installation
issue. For more help, contact the system administrator.
Wait. No action needed.
Change the print-quality mode in the print driver to Standard.
on page 29.
Print Speed on page 224.
Printing the