Xerox Phaser 6510 User Manual page 49

Assigning the IP Address Automatically
1. At the printer control panel, press Menu.
Note: To navigate through the menu, use the arrow buttons.
Navigate to Admin Menu, then press OK.
2.
3. Navigate to Network/Port, then press OK.
4. Navigate to TCP/IP Settings, then Press OK.
Navigate to Ethernet, then press OK.
5.
6. Navigate to Get IP Address, then press OK.
Navigate to DHCP/AutoIP, then press OK.
7.
8. Power off the printer, then power it on again.
9. Two minutes after the printer restarts, verify that the printer has obtained a valid IP Address.
For details, refer to Finding the IP Address of Your Printer
Installation and Setup
on page 30.
Xerox Phaser 6510 Color Printer
® ®
49
User Guide