Associating A Port To A Vrf Instance - Nortel 8600 Configuration Manual

60 Ethernet module configuration using the NNCLI
Variable
wan-mode [enable] [port
<portList>]

Associating a port to a VRF instance

Associate a port to a Virtual Router Forwarding (VRF) so that the port
becomes a member of the VRF instance.
You can assign a VRF instance to a port after the VRF is configured. Ports
are assigned to the Global Router, VRF 0, by default.
For more information about VRF Lite, see Nortel Ethernet Routing Switch
8600 Configuration — IP Routing (NN46205-523).
Prerequisites
•
You must be in Interface Configuration mode.
Nortel Ethernet Routing Switch 8600
Configuration — Ethernet Modules
NN46205-503 04.01 21 December 2009
Copyright © 2008-2009 Nortel Networks. All Rights Reserved.
Value
Use port <portList> to change other ports
to the same settings.
The default form of this command is default
tx-flow-control [port <portList>]
[enable].
The no form of this command is no
tx-flow-control [port <portList>]
[enable].
Enables or disables WAN mode. This
parameter is applicable only to the 8683XZR
module. If you enable WAN mode, the port
uses SONET or SDH. Use port <portList>
to change other ports to the same settings.
When you configure multiple ports of the
8683XZR module to WAN mode, the framing
type and clock mode must be the same for all
the WAN mode ports. Mixed configurations
for multiple WAN mode enabled ports is not
supported.
The default form of this command is default
wan-mode [enable] [port <portList>].
The no form of this command is no wan-mode
[enable] [port <portList>].