Displaying And Maintaining Vlan - HP 5820X series Configuration Manual

To do...
5. Enter
interface
view or port
group view
6. Configure port link type as hybrid
7. Configure the hybrid ports to
permit the specified IP subnet-
based VLANs to pass through
8. Associate the hybrid ports with the
specified IP subnet-based VLAN
After you configure a command on a Layer 2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do that
on the aggregate interface, it stops applying the configuration to the aggregation member ports. If it fails
to do that on an aggregation member port, it skips the port and moves to the next port.

Displaying and maintaining VLAN

To do...
Display VLAN information
Display VLAN interface
information
Display hybrid ports or trunk ports
on the device
Display MAC address-to-VLAN
entries
Display all interfaces with MAC-
based VLAN enabled
Use the command...
Enter Ethernet interface interface-type
interface view interface-number
Enter Layer 2
interface bridge-aggregation
aggregate
interface-number
interface view
Enter port group port-group manual port-group-
view name
port link-type hybrid
port hybrid vlan vlan-id-list
{ tagged | untagged }
port hybrid ip-subnet-vlan vlan
vlan-id
Use the command...
display vlan [ vlan-id1 [ to vlan-id2 ] | all |
dynamic | reserved | static ] [ | { begin |
exclude | include } regular-expression ]
display interface vlan-interface [ vlan-
interface-id ] [ | { begin | exclude |
include } regular-expression ]
display port { hybrid | trunk } [ | { begin |
exclude | include } regular-expression ]
display mac-vlan { all | dynamic | mac-
address mac-address [ mask mac-mask ] |
static | vlan vlan-id } [ | { begin | exclude |
include } regular-expression ]
display mac-vlan interface [ | { begin |
exclude | include } regular-expression ]
125
Remarks
Required.
Use either command.
• In Ethernet interface view,
the subsequent
configurations apply to the
current port.
• In port group view, the
subsequent configurations
apply to all ports in the port
group.
• In Layer 2 aggregate
interface view, the
subsequent configurations
apply to the Layer 2
aggregate interface and all
its member ports.
Required.
Required.
Required.
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in any view