Ip Subnet-Based Vlan Configuration; Configuring An Ip Subnet-Based Vlan - HP 5820X series Configuration Manual

Protocol Index
======================================================
1
VLAN ID:200
Protocol Index
======================================================
1
# Display protocol-based VLAN information on the ports of Device.
[Device-GigabitEthernet1/0/2] display protocol-vlan interface all
Interface: GigabitEthernet 1/0/1
VLAN ID
======================================================
100
200
Interface: GigabitEthernet 1/0/2
VLAN ID
======================================================
100
200
Configuration guidelines
Protocol-based VLAN configuration applies to hybrid ports only.

IP Subnet-based VLAN configuration

In this approach, packets are assigned to VLANs based on their source IP addresses and subnet masks. A
port configured with IP subnet-based VLANs assigns a received untagged packet to a VLAN based on the
source address of the packet.
This feature is used to assign packets from the specified network segment or IP address to a specific VLAN.

Configuring an IP subnet-based VLAN

This feature is only applicable on hybrid ports.
To configure an IP subnet-based VLAN:
To do...
1. Enter system view
2. Enter VLAN view
3. Associate an IP subnet with the
current VLAN
4. Return to system view
Protocol Type
ipv4
Protocol Type
ipv6
Protocol Index
1
1
Protocol Index
1
1
Protocol Type
ipv4
ipv6
Protocol Type
ipv4
ipv6
Use the command...
system-view
vlan vlan-id
ip-subnet-vlan [ ip-subnet-
index ] ip ip-address [ mask ]
quit
124
Remarks
—
—
Required.
The IP network segment or IP
address to be associated with a
VLAN cannot be a multicast
network segment or a multicast
address.
—