Protocols And Standards; Mstp Configuration Task List - HP 5820X series Configuration Manual

Loop guard
•
TC-BPDU guard
•
BPDU drop
•

Protocols and standards

MSTP is documented in:
IEEE 802.1d: Media Access Control (MAC) Bridges
•
IEEE 802.1w: Part 3: Media Access Control (MAC) Bridges—Amendment 2: Rapid Reconfiguration
•
IEEE 802.1s: Virtual Bridged Local Area Networks—Amendment 3: Multiple Spanning Trees
•

MSTP configuration task list

Before configuring MSTP, you must plan the role of each device in each MSTI, root bridge or leaf node,
and then configure the devices as planned. In each MSTI, only one device acts as the root bridge, and all
others as leaf nodes.
Complete these tasks to configure MSTP:
Task
Configuring the root
bridge
Configuring an MST region
Configuring the root bridge or a secondary root bridge
Configuring the work mode of an MSTP device
Configuring the priority of a device
Configuring the maximum hops of an MST region
Configuring the network diameter of a switched network
Configuring timers of MSTP
Configuring the timeout factor
Configuring the maximum port rate
Configuring ports as edge ports
Configuring the link type of ports
Configuring the mode a port uses to recognize/send MSTP
packets
Enabling the output of port state transition information
Enabling the MSTP feature
70
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Required