Configuring the Transparent mode management IP address
•
Login to the CLI if you are not already logged in.
•
Set the IP address and netmask of the Management IP to the IP address and netmask that you recorded
in
Transparent mode configuration
set system manageip ip <IP Address> <Netmask>
Example
set system manageip ip 10.10.10.2 255.255.255.0
•
Confirm that the address is correct. Enter:
get system manageip
The CLI lists Management IP address and netmask.
Configure the Transparent mode default gateway
•
Login to the CLI if you are not already logged in.
•
Add a default route set to the Default Gateway IP Address that you recorded in
configuration
information. Enter:
set system manageip gateway <IP Address>
Example
set system manageip gateway 192.168.1.20
You have now completed the initial configuration of the DFL-500 and you can proceed to connect the
DFL-500 to your network using the information in
Connecting the DFL-500 to your network
Once the initial configuration of the DFL-500 is complete, you can connect the DFL-500 between your internal
network and the Internet. The connection procedures are the same whether you are running in NAT mode or
Transparent mode.
There are two 10/100 BaseTX connectors on the DFL-500:
•
Internal for connecting to your Internal network
•
External for connecting to your public switch or router and the Internet
To connect the DFL-500:
•
Connect the Internal interface to the hub or switch connected to your internal network.
•
Connect the External Interface to the public switch or router provided by your Internet Service Provider.
DFL-500 User's Manual
information. Enter:
Connecting the DFL-500 to your network
Transparent mode
that follows.
21