Configuring The Dfl-500 To Run In Transparent Mode - D-Link DFL-500 User Manual

set system interface internal ip 192.168.1.1 255.255.255.0
•
Set the IP address and netmask of the external interface to the External IP Address and Netmask that
you recorded in NAT mode configuration
To set the Manual IP address and netmask, enter:
set system interface external manual ip <IP Address> <Netmask>
Example
set system interface external manual ip 204.23.1.5 255.255.255.0
To set the external interface to use DHCP enter:
set system interface external dhcp
To set the external interface to use PPPoE enter:
set system interface external pppoe <user name> <password>
Example
set system interface external pppoe username password
•
Confirm that the addresses are correct. Enter:
get system interface
The CLI lists the IP address and netmask settings for each of the DFL-500 interfaces as well as the mode
of the external interface (manual, DHCP, or PPPoE).
Configure the NAT mode default gateway
•
Login to the CLI if you are not already logged in.
•
Set the default route to the Default Gateway IP Address that you recorded in
information. Enter:
set system route add 0.0.0.0 0.0.0.0 gw <IP Address> dev external
Example
set system route add 0.0.0.0 0.0.0.0 gw 204.23.1.2 dev external
You have now completed the initial configuration of the DFL-500 and you can proceed to connect the
DFL-500 to your network using the information in

Configuring the DFL-500 to run in Transparent mode

The procedures in this section describe how to use the CLI to configure the DFL-500 to run in Transparent
mode.
Changing to Transparent mode
•
Login to the CLI if you are not already logged in.
•
Switch to Transparent mode. Enter:
set system status opmode 2
After a few seconds, the following prompt appears:
D-Link login:
•
Type admin and press Enter.
The following prompt appears:
Type ? for a list of commands.
•
Confirm that the DFL-500 has switched to Transparent mode. Enter:
get system status
The CLI displays the status of the DFL-500. The last line shows the current operation mode.
Version:DFL-500 2.20,build016,020326
virus-db:2.104(03/19/2002 14:10)
Serial Number:FGT-502801021075
Operation mode:transparent
DFL-500 User's Manual
information.
Connecting the DFL-500 to your
NAT mode configuration
network.
20