Advertisement
72
V. FRAME
3. The steering stem nut should be tightened after temporarily
installing the front shock absorbers.
~
Fig. 5-38
(1) Steering stem nut
(2) Bolt
(3) Fork top bridge
Steering handlebar
1. Install the engine stop switch and tUffi signal switch to the
handlebar. To do this, tie a wire or the like to the ends of
the wirings and pass it through the pipe, being careful not
to twist or kink the wirings.
/
Fig. 5-39
Passing wire through handlebar
lnstall the handlebar, aligning the punch marks on the
handlebar with the mating edges of the upper and lower
holders.
The punch mark on the upper holder should be pointed
toward the front of the machine. When fastening the upper
holder to the lower holder, tighten the bolt at the front
first and then the ones at the rear.
3. Route the each cable and wiring properly as shown.
NOTE:
Check to be sure that each cable and wiring is free from
bicding or twisting when turning the steering handlebar
ful1y to either left or right side.
Fig. 5-41
(l) Outch cable
(2) Brakehose
(3) Throttle cable
Advertisement
