Advertisement
V. FRAME
63
6. Remove the speedometer gear box, gear box retainer cover,
gear box retainer and O-fingo
7. Remove the oil seals from the speedometer gear box and
wheel hub.
Fig. 5-4
(1) Front wheel axle
(3) Gear box retainer cover
(2) Speedometer gear box (4) Gear box retainer
8. Remove the bearing retainer with "Bearing Retainer
Wrench" (Tool No. 97910-3230101).
9. Remove the ball bearings and spacercollar from the front
wheel hub.
[nspection
l. Check the front wheel axIe bendo
Standard value:
O.OSmm (O.OO20-in.) max.
Service limit:
O.2mm (O.OO79-in.)
2. Check the spokes far looseness, bend or any other damage.
3. Check the front wheel rim far face runout.
Standard value: O.Smm (O.O197-in.) max.
Fig. 5-5
(1) Bearing retainer wrench
4. Check the brake disc far warpage.
Piace the brake disc on a surface plate with the indicating
needle of a dia! gauge resting against the brake disco
Measurements should be taken in the several places aver the
brake disc by moving the indicator needle as necessary.
Service Iimit:
O.O5mm (O.O20-in.)
5. Check the brake disc for face runout.
.
With the disc installed, hold the front wheel axle and
measure the face runout of the disc with a dial gauge.
St'lndard value: O.OSmm (O.OO2O-in.) max.
Service limit:
0.3 mm I (0.012-in.)1
6. Measure the thickness of the brake disco
Standard value: 6.9-7.1mm (0.2717-0.279S-in.)
Service limit:
6.0mm (O.2362-in.)
tolg. .')-6
(1) Brake clIsC
(2) Dia! gauge
(3) Measuring points
Assembly
l. Hand pack the wheel bearings and wheel hub with
recommended grease. Drive the ball bearings into pIace in
the hub using "Bearing Driver Attachment"
(Tool No.
07946-9350200) and
"Driver
Handle"
(Tool
No.
07949-6110000).
NOTES:
a. Do not forget to install the spacer collar.
b. Install the bearings with the seal side toward the outside.
Pig. 5-1
(1) Seal side ofball bearing
Advertisement
