Advertisement
40
IV. ENGINE
8. GEARSHIFTMECHANISM
~
A group: On-frame servicing
B group: Off engine servicing
(Se e page 42.)
Fig, 4-61
(1) Snap ring (12mm)
(2) Gearshift spindle stop
(3) Gearshift spindle
(4) Gearshift return spring
(5) Gearshift arm spring
(6) Retum spring pin
(7) Shift drum stopper
(8) Shift drum stopper spring
(9) Neutral stopper spring
(lO) Shift drum stop per collar
(11) Neutral stopper
(12) Bearing set plate
(13) Gearshift drum pin
(14) Caro plate
(15) Gearshift drum center
(16) Ball bearing (16004)
(17) Knock pin (4 x 8mm)
(18) Gearshift drum
(19) Rigi1t gearshift foik
(20) Center gearshift fork
(21) Left gearshift fork
(22) Gearshift fork guide pin
(23) Guide pin clip
(24) ail seal (12 x 25 x 4.5mm)
Disassembly
A group
1. Drain the engine thoroughly.
2. Remove the right muffler, kick starter perla! and right step
bar...3.
Remove the right crankcase cover, oil filter, clutch and oil
pump. (See page 36.)
4. Remove the gearshift pedal and left crankcase rear cover.
5. Pry off the snap ring securing the gearshift spindle in piace.
Fig. 4-62
(1) Gear shift spindle
(2) Snap ring
6. Withdraw the gearshift spindIe while disengaging the
gearshift arm hook from the gearshift drum.
Fig. 4-63
(1) Gearshift arm
(2) Gearshift drum
(3) Gearshift spindle
Advertisement
