Usb Cable Assembly - Intermec pm43 Service Manual

TITLE
PM43 Service Work Instructions

USB Cable Assembly

OPERATION:
This section covers the replacement of front panel USB assembly. The front panel USB option is only available for PM43.
PM43c does not have this option.
To replace the USB connector, the full-touch/ICON front panel need to be removed first for PM43.
Tools Required
Description
Torx Driver
Parts Required
Item Part Number
1 234-068S-002
2 800-593-006
Front Panel USB Cable Assembly Replacement
1. Remove the front panel to access the USB cable assembly for replacement. See page 11 on how to remove the front panel.
2. Remove the torx screws securing the USB PCBA to the front panel and remove the front panel USB connector. See Figure 1.
3. Disconnect the USB cable from connector P26 on the main logic board (MLB).
4. Reverse the procedure for re-installation.
Description
Front USB Receptacle, Cable Assembly
Screw, Plastite, M3x6, PH, Torx, T10 (3 lbf.in/3.5kgf.cm)
Figure 1
Intermec Proprietary Document
Model
PM43,PM43C
Part Number
T10
2
DOCUMENT NO.
SWIPM43x-000
Qty
1
2
1
Front Panel USB Cable Assembly
PAGE
Page
40 of 70