Ribbon Adjust Sub Assembly - Intermec pm43 Service Manual

TITLE
PM43 Service Work Instructions

Ribbon Adjust Sub Assembly

OPERATION:
The purpose of the ribbon adjust assembly is to adjust the ribbon alignment for ribbon wrinkle for printers with thermal
transfer ribbon option. Direct thermal printer will not have the ribbon adjust sub-assembly.
Tools Required
Description
Torx Driver
Torx Driver
Parts Required
Item Part Number
1 710-099S-001
LSS Upper Sensor Assembly Replacement
1. Remove the torx screw securing the ribbon adjust assembly. See Figure 1.
2. Slide the ribbon adjust assembly toward the electronics and gears side to remove from the spine (main deck).
3. Reverse the instructions for re-installation.
Description
Ribbon Adjust Sub Assembly, Spare (include screws, washer, rod, and plate)
Figure 1
Intermec Proprietary Document
Model DOCUMENT NO.
PM43,PM43C
Part Number
T10
T20
Torx screw
Ribbon Adjust Sub Assembly, Spare
PAGE
SWIPM43x-000
29 of 70
Qty
1
1
Page