Intermec pm43 Service Manual page 16

TITLE
PM43 Service Work Instructions
Bottom Base Print Mechanism
(Does not include tear bar and screws as shown)
Printhead Pressure Adjust Assembly Replacement
1. Turn the printhead lift lever counterclockwise to raise the printhead. See page 13 on the direction of printhead lift lever.
2. Remove the 5 torx screws securing the printhead pressure adjust assembly. See Figure 2 on location of torx screws.
3. Prior to removing the printhead pressure adjust assembly, it is
posts. See Figure 3, Figure 4, and Figure 5.
4. Reverse the procedure for installing the replacement printhead pressure adjust assembly.
Guide posts
1
IMPORTANT
Figure 2 – Printhead Pressure Adjust Assembly
Intermec Proprietary Document
Model DOCUMENT NO.
PM43,PM43C SWIPM43x-000
TPH Pressure Adjust
to note the position of the crank lever and guide
2
x5
PAGE
Page
16 of 70
Media Guide
Adjustment lever
2