System Information; Offset Mode - Chauvet ROGUE R1 FX-B User Manual

System Information

All information about the current status of the Rogue R1 FX-B is available through the product's Sys
Info menu. To view this information, follow the instructions below:
1.
2.
3.
4.
5.
6.
The Offset mode provides fine adjustments for the home position of all the moving parts in the

Offset Mode

optical path as well as the pan and tilt movements. This way, when in their home position, the
moving parts do not show any border or reduce the light output.
1. Starting from the Main Level screen, press and hold <MENU> until the passcode screen
2. Enter the passcode 2323 using one of the following methods:
3. Press <ENTER>.
This brings you into the Zero Adjust menu screen.
PAN To adjust the starting point of the pan motor, follow the instructions below:
1. Use <UP> or <DOWN> to select PAN.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the starting value, from 000–255.
4. Press <ENTER>.
TILT To adjust the starting point of any of the tilt motors, do the following:
1. Use <UP> or <DOWN> to select TILT1, TILT2, TILT3, TILT4, or TILT5.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the starting value, from 000–255.
4. Press <ENTER>.
MAC Address To assign the fourth, fifth, or sixth digit of the MAC address, follow the instructions below:
1. Use <UP> or <DOWN> to select MAC4, MAC5, or MAC6.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the value, from 000–255.
4. Press <ENTER>.
Rogue R1 FX-B User Manual Rev. 2
Press <MENU> repeatedly until the Home Screen shows on the display. Press <ENTER>.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Sys Info, or touch the display where it
says Sys Info.
If using the buttons instead of the touchscreen, press <ENTER>.
Use <UP> or <DOWN> to select from Fixture Information (shows firmware version, running
mode, starting address, etc.), Error Information (shows any errors or No Error!), or Channel
Information (shows the current value of all signal input channels) or touch the display where it
says the desired option.
Press <ENTER>.
Use <UP> or <DOWN> to scroll through the information.
appears.
·
Through the touchscreen: use the number pad on the screen to enter 2323.
·
With the buttons:
a. Use <DOWN> to select the number to be changed.
b. Use <UP> to increase the value.
c. Repeat until 2323 has been entered.
Operation
-53-