OM-2031
1. Actuator shaft
2. Signal input connector
3. Actuator lever
4. Ball joint, actuator
(2) Magnetic pickup adjustment
The strength of the magnetic pickup signal to the control box can be weakened if the tip of the pickup
is too far from the flywheel ring gear. If the pickup is to be removed for any reason, or if the signal is
weak (less than 2.5-V AC) as indicated by a voltage test at the pick-up with the engine running at
rated speed, proceed as follows:
(a) Disconnect "pull-apart" connector (1, Fig. 5).
(b) Loosen nut (3) and remove magnetic pickup (2).
(c) Inspect to make certain the tip is not damaged from contact with the ring gear teeth, replace
pickup if damaged.
2-3
Page 12
5. Nut
6. Rod
7. Ball Joint, Fuel Control Lever
Governor Actuator Linkage
Figure 4
August 5/89 Revised