Table of Contents
Advertisement
(c) Each terminal stud is identified by an identification plate. Each cable should be identified by a
band-type marker. Connect cable "A" to terminal "A", "B" to "B", etc. Tighten terminal nuts se-
curely. Connect small plug interlock lead "E" or "F" to terminal "E" or "F".
(d) Tighten clamp screws securely, but avoid damage to cable insulation.
(2) Transformer-rectifier (DC) output cable installation (optional equipment) . Install DC output cables
as illustrated in Figure 2. Use 4/0 size cables.
August 5/89 Revised
AC Output Terminal Panel
Figure 1
OM-2031
1-2
Page 3
Advertisement
Table of Contents
