Section 5 Configuration File Programming
Description
Value Range
Default Value
5.6.2 Tone Settings
DIAL_TONE1_FRQ
Value Format
Description
Value Range
Default Value
Web User Interface Reference
DIAL_TONE1_GAIN
Value Format
Description
Value Range
Default Value
DIAL_TONE1_TIMING
Value Format
Description
Value Range
Default Value
146
Administrator Guide
Selects whether a tone is heard in response to key presses.
Note
•
This setting does not affect the iWnn IME Keyboard. For details
about available keyboards, refer to the Operating Instructions
on the Panasonic Web site (® see Introduction).
•
If touch tones or selection tones are configured through phone
user interface programming, changes to this setting are
ignored.
•
Y (Enable Key Pad Tone)
•
N (Disable Key Pad Tone)
Y
Comma-separated Integer
Specifies the dual-tone frequencies, in hertz, of Dial Tone 1 using 2
whole numbers separated by a comma.
0, 200–2000 (0: No tone)
350,440
Tone Frequencies (Page 98)
Integer
Specifies the gain, in decibels, of Dial Tone 1.
-24–6
0
Comma-separated Integer
Specifies the pattern, in milliseconds, of Dial Tone 1 using up to 10
whole numbers (off 1, on 1, off 2, on 2...) separated by commas.
Note
•
It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
0–16000 (0: Infinite time)
60,0
Document Version 2011-11