Unpack And Inspect The Calibrator; Placement And Rack Mounting - Fluke 5730A Getting Started Manual

Unpack and Inspect the Calibrator

The 5730A Calibrator ships in a container that prevents shipping damage. Inspect the
Calibrator carefully for damage, and immediately report any damage to the shipper.
Instructions for inspection and claims are included in the shipping container.
When the Calibrator is unpacked, check for all the standard equipment listed in Table 3
and check the shipping order for additional items ordered.
Item
Calibrator
Mains Power Cord
5730A Getting Started
5730A Manual CD (Containing the Operators
Manual)
Certificate of Calibration

Placement and Rack Mounting

Put the 5730A Calibrator on top of a bench or mount in a standard-width, 24-inch
(61-cm) deep equipment rack. For bench-top use, the Calibrator has non-slipping,
non-marring feet. To mount the Calibrator in an equipment rack, use the Rack Mount
Kit (Model Y5737) or the Rack Ear Kit (Model Y5738). Instructions are included
with the kit.
To prevent possible electrical shock, fire, or personal injury, do
not restrict access to the Calibrator mains power cord. The
mains power cord is the mains disconnecting device. If access
to the power cord is inhibited by rack mounting, a properly-
rated accessible mains disconnecting switch must be provided
within reach as part of the installation.
Table 3. Standard Equipment
5730A
See Table 2-2 and Figure 2-1 in the Operators
Manual.
4290571
4290580
No part number
Warnings
Multifunction Calibrator
Unpack and Inspect the Calibrator
Model or Part Number
11