Ieee 802.11B (Wireless Lan) - Ricoh B230 Service Manual

1.20.7 IEEE 802.11B (WIRELESS LAN)

Installation Procedure
Unplug the main machine power cord before you do the following
procedure.
You can only install one of the following network interfaces at a time: (IEEE 802.11b
(Wireless LAN), IEEE1284, Bluetooth).
1. Remove the slot cover [A] from I/F Card Slot B (
2. Install the wireless LAN board (Knob-screw x 2) into I/F card slot B.
3. Install the wireless LAN card [B] in the wireless LAN board [C]. Make sure the
card label faces to the front of the machine.
4. Attach the cover [D] to the wireless LAN card.
5. Make sure that the machine can recognize the option (see 'Check All
Connections' at the end of this section).
You may have to move the machine if the reception is not clear.
1. Make sure that the machine is not located near an appliance or any type of equipment
that generates strong magnetic fields.
2. Put the machine as close as possible to the access point.
UP Mode Settings for Wireless LAN
Enter the UP mode. Then do the procedure below to perform the initial interface settings for
IEEE 802.11b. These settings take effect every time the machine is powered on.
You cannot use the wireless LAN if you use Ethernet.
SM
x 2).
1-71 B230/B237/D042