11.1 Warranty; 11.2 Service Policy; 11.3 Calibration Policy - AMERITECH AM5 Instruction Manual

AM5 (e) Classic Instruction Manual
11. WARRANTY, SERVICE AND CALIBRATION

11.1 WARRANTY

AMERITEC Corporation warrants that its electronic instrument products are manufactured to the
highest commercial standards and are free from any defects in material or workmanship.
For a period of one (1) year from shipment, AMERITEC will repair, without charge to the original
purchaser, any unit which upon inspection by AMERITEC proves to be defective.
This warranty is the sole warranty offered by AMERITEC and is in lieu of all other obligations or
liabilities, including claims of consequential damage; however, an EXTENDED WARRANTY
PLAN may be purchased. For information contact an Ameritec Sales Representative.

11.2 SERVICE POLICY

AMERITEC products are designed with plug-in printed circuit boards and modular
assemblies. Once a problem is localized, service is accomplished by PC board (or module)
replacement.

11.3 CALIBRATION POLICY

All AMERITEC products are manufactured to commercial standards and are calibrated with
equipment traceable to NIST (National Institute of Standards and Technology). With the
exception of component failures or abuse, AMERITEC instruments are designed to maintain
compliance with their published specifications throughout their service life.
While periodic calibration verification is normally not required, in critical applications it is
recommended that verification be accomplished annually.
Calibration verification is most efficiently accomplished by return of the equipment to the
AMERITEC factory where specialized test equipment is used. Field calibration verification is not
supported by AMERITEC.
November 19, 1997 Page 11-1
(18-0047) WARRANTY, SERVICE AND CALIBRATION