Table of Contents
Advertisement
AM5(e) Classic Instruction Manual
3.5
OPTIONAL FACTORY-INSTALLED EQUIPMENT
This sub-section describes the features that must be ordered for the AM5(e) Classic before
shipment. Other accessories that can be ordered at any time are described in sub-section
3.6.
3.5.1
Sealed Lead-Acid Batteries and Integral Charger (Option 24-0017): These
batteries are located inside the case and provide five to eight hours of operation
without any external power connection. The charger permits the batteries to be
charged while the unit is in operation or turned OFF. The battery pack adds
approximately four pounds (1.8 kg) to the weight of the AM5(e) Classic .
3.5.2
Siemens type "banana" input adapter for AM5e Classic only (Option 25-
0041): The "banana" input adapter brings the line connections to two in-line
socket connectors that are designed to mate with lines that are connected with a 3-
pronged Siemens-type Banana connector. This is a standard in some European
countries. The adapter is mounted on the bottom of the AM5e Classic , flush with
the front panel. Refer to the front cover of this manual for a view of this unit
mounted underneath the AM5e Classic.
3.5.3
Model 30-0033XT Signaling Adapter with Ring Generator: This is an adapter
unit which is attached to the clips on the left- and right-front sides of the AM5(e)
Classic .
The Signaling Adapter provides Loop Start, Ground Start, DID, and Types I, II,
and III E & M signaling. The adapter also incorporates a ring generator with
manual cadence selection and automatic ring trip.
The adapter supplies both 24 and 48 Volt DC loop supply voltage with a switch
to allow for simulation of a 1240 ohm loop resistance.
LED indicators are provided to indicate signaling status.
Bantam connectors are used for access to E & M, SB/SG, Line Tip and Ring,
and the connection to the AM5(e) Classic.
The Signaling Adapter is separately powered by 115 Volts AC.
For more information refer to the "AM5XT Signaling Adapter Models 30-0033
and 30-0033XT Instruction Manuals" (P/N 180023) or contact Ameritec
Corporation Sales Representative.
Note: "Adapter" is alternate spelling on front panel of this particular unit.
November 19, 1997
(18-0047)
Page 3-17
DESCRIPTION
Advertisement
Table of Contents
