3.4.5 Screw Terminal, Ground; Screw Terminals, T1 And R1; Screw Terminals, T And R; Figure 3-4 - Am5(E) Classic Rear Panel Drawing - AMERITECH AM5 Instruction Manual

AM5(e) Classic Instruction Manual

3.4.5 Screw Terminal, Ground:

the front-panel bantam jacks. Ground (connected at either location)is required for
the reference in the NTG (Noise to Ground) Test. (NTG test is described in Section
6.)
3.4.6 Screw Terminals, T1 and R1: These are the same connections as the Tip and Ring
of the right front-panel bantam jack (RX).
3.4.7 Screw Terminals, T and R: These are the same connections as the Tip and Ring of
the left front-panel bantam jack (TX/2W).
115V/230V voltage selector
Rear support
Optional Rear-Panel Self-Test
Connections
T
(TX/2W)
Power Cord Connection
Figure 3-4 — AM5(e) Classic Rear Panel Drawing
November 19, 1997
This is the same connection as the Sleeve contacts on
R T1 R1
(Sleeves)
(RX)
(18-0047)
Rear support
CAUTION
•
VERIFY PROPER VOLTAGE
SELECTION BEFORE
CONNECTING POWER
use 1/2A fuse
Location of Fuse Holder
Page 3-16
DESCRIPTION
•