Table of Contents
Advertisement
AM5(e) Classic Instruction Manual
3.
PHYSICAL AND FUNCTIONAL DESCRIPTION
This section describes the general physical characteristics of the AM5(e) Classic, the
Front and Rear Panel controls, indicators, and connectors, and the optional equipment.
3.1
PHYSICAL CHARACTERISTICS
3.1.1 Weight: The AM5(e) Classic weighs six (6) pounds (2.7 kilograms) without the
optional battery pack, and 10 pounds (4.5 kilograms) with the battery pack.
3.1.2 Portable Dimensions: The AM5(e) Classic in its portable case measures 8.3 in.
(210 mm) wide, 3.5 in. (89 mm) high, and 12.1 in. (307 mm) deep. With the
optional snap-on cover in place, the Classic is 14 in. (356 mm) deep.
3.1.3 Rack Mounted Dimensions: A 19 in. Rack Mount kit (P/N 850076) can be
ordered for fixed installations. When mounted in the Rack Mount kit, the
AM5(e) Classic measures 19 in (483 mm) wide, 3.5 in. (89 mm) high, and 12.1 in.
(307 mm) deep. A Rack Mount kit shelf is also available (P/N 850233). For more
detail refer to sub-section 3.6.5.
3.1.4 Construction: The front panel (with switch and indicators labels appropriate for
the AM5 Classic or AM5e Classic ) and a black, steel rear panel are attached to a
sturdy aluminum case. Within the case, electronic components are mounted on
three plug-in printed circuit boards, interconnected with ribbon cables. The AC
power supply and optional battery pack with charging circuitry are also
contained within the case.
CAUTION: None of the electronic components within the case are user-
serviceable, and opening the case will void the manufacturer's warranty.
3.1.5 Rubber Feet: There are four (4) rubber feet on the bottom of the case, and two
rear-panel support brackets for positioning the AM5(e) Classic horizontally or
vertically during operation. There are also four (4) rubber feet on the left side for
setting it down after carrying it with the carrying handle.
3.1.6 Carrying Handle: The carrying handle is made of thick, soft, flexible
plastic. It is located on the right side of the case. It extends for use and retracts
against the case when not in use.
NOTE: Neither the rubber feet nor the carrying handle are provided when the AM5(e)
Classic is installed in the 19 inch Rack Mount kit (P/N 850076).
3.2
FRONT PANEL DESCRIPTION
The front panel measures approximately 3 in. (75 mm) high by 8 in. (205 mm) wide.
Both panels are illustrated in Figures 3-1 and 3-2. The panels are similar in appearance
with the exception of the label nomenclature for filters, certain noise measurements,
and DIAL terminal identification.
November 19, 1997
(18-0047)
Page 3-1
DESCRIPTION
Advertisement
Table of Contents
